Corn Peeling Machine Chassis and Centrifugal Unloader

Corn peeling machine can’t lack the support from chassis. Before usage, we should install corn peeling machine chassis correctly. It is necessary to master some installation skills.
...

Corn peeling machine can’t lack the support from chassis. Before usage, we should install corn peeling machine chassis correctly. During corn peeling machine chassis installation, it is necessary to master some installation skills.


Besides of the CORN PEELING MACHINE chassis and the power shaft, even the grinding cone which connects with the power shaft and is assorted with the mill with the feeding inlet, should be installed correctly. We can install the clearance adjustment mechanism for the mill and the grinding cone along the axial direction of the power shaft. Then we can adjust corn peeling machine according to grain granularity (such as corn and wheat) so as to meet requirements for different customers.

Corn peeling machine has a feeding pipe on one side of the top of the centrifugal unloader shell. And the upward side of the centrifugal unloader shell has an air duct. One side of the centrifugal unloader shell has the impurities discharging port, on which has the screen. Outside of the screen is the cover board. Under the impurities discharging port is the change-over valve, which connects with the impurities discharging pipe and can remove the dust and other sundries from the grains completely. This design of corn peeling machine has low cost and low energy consumption. 

During corn peeling machine operation, we should strictly abide by the operation specification and do well in corn peeling machine safety protection. Then we can pay attention to the relations between each system of the machine. Finally, we should be clear that no machine is rigid, but can be controlled flexibly.